Silver Coring Tools and Supplies

Click for Detail	Dave's Deburing Tool Just one or two gentle spins of this tool removes the bur from the tubing ends, leaving a perfectly chamfered end, which translates to a smooth, shiny, perfectly shaped rivet edge. Just about 3 seconds per end. It's effortless!
	Price:	$14.50
	Qty:
	dave@artintheround.com
Click for Detail	Impress Bead Liner An inexpensive, easy to use, yet remarkably effective tool for lining your beads with silver.
	Price:	$85.00
	Qty:
	dave@artintheround.com
Click for Detail	Riser Kit for Impress These steel blocks raise the height by 3/4 inch, to allow a 1and 1/2 inch tube height. They are easily installed by removing the two screws from the base plate and replacing them with these and the two longer screws supplied with the kit. All you need is a #2 Philips screwdriver. For even greater height, they may be stacked. You'll need the 2 inch screws for that, which are listed in this same catalog section.
	Price:	$14.00
	Qty:
	dave@artintheround.com
	Centering Pegs for Impress The Impress comes with a centering peg for 1/4 inch OD / .218 ID tubing pre-installed. These pegs fit other sizes of tubing. Just unscrew the standard peg and replace it with one of these. You will need a #2 Philips screwdriver for that. The 1/4 inch peg comes free, so don't order that size unless you want an extra one, or a replacement for a lost one.
	Price:	$6.00
	Size:	5 mm OD / 4.1 mm ID (.200 inch OD / .162 inch ID)5 mm OD / 3.8 mm ID (.200 inch OD / .15 inch ID)5.5 mm OD / 4.2 mm ID (.216 inch OD / .165 inch ID)6 mm OD / 4.6 mm ID (.240 inch OD / .181 inch ID)6 mm OD / 5.0 mm ID (.240 inch / .197 inch ID)6 mm OD / 5.1 mm ID (.240 inch / .201 inch ID)3/16 .188 inch OD / .156 inch ID (4.8 mm OD /4.0 mm ID)1/4 .250 inch OD / .218 inch ID ( 6.35 mm OD / 5.5 mm ID)Special peg for 4.37 mm ID
	Qty:
	dave@artintheround.com
	2 inch screws for double stack risers Two 2 inch screws for double-stacking the Impress risers.
	Price:	$0.50
	Qty:
	dave@artintheround.com
	Flaring Die for 1/8 OD X 3/32 ID 1/8 inch mandrel beads
	Price:	$12.00
	Qty:
	dave@artintheround.com
	Flaring Die for 3/32 OD X 1/16 ID 3/32 mandrel beads 3/32 tubing works great for attaching bead caps! But because it is so small, don't expect a big wide lip like you get with large tubes!
	Price:	$12.00
	Qty:
	dave@artintheround.com
	Both 1/8 and 3/32 Dies at a 10% Discount!
	Price:	$21.60
	Qty:
	dave@artintheround.com
	Flaring Die for 5/32 OD X 1/8 ID tubes for 5/32 mandrel beads
	Price:	$12.00
	Qty:
	dave@artintheround.com